Air In Pool Pump Lines

When air exists in the intake line and the pump chamber the pump cannot draw water.

Air in pool pump lines.

Removing air from a pool line involves priming the system with water to enable the pump to push the air out. After the pump restarts and primes water flows normally and air bubbles eventually cease. What happens when i. By the time the pump turns back on the lines are empty.

The last and most serious issue that could be occurring is air entering through cracked lines between the skinner and the pump. Another part of the pool s pump that can allow air to get into water return lines is the pool pump lid s seal rubber o ring or gasket. Pumpbasket filtersystem for more details and to purchase please visit. Using the above pool pump troubleshooting tips above you should be able to remove all the air from your swimming pool pump.

Start with the suction side and move to the pressure side. You can blow out your own pool lines with an air compressor or a wet rated powerful shop vacuum if you have the right components. Over time air becomes trapped inside the filter causing pressure to build up inside the filter body. Over the 8 hours when the pump is not running air is getting into the lines above pool water level.

This can only truly be checked by means of a pressurization test to see if the line holds air pressure and should be checked by a professional pool service company. Filters pull water through the pool s plumbing pass it through the filter contained in the filter body which removes the debris and return the water through the pool s return lines. But it s important to be thorough. And blow out pump components heaters and filter components this is a good time to clean skimmer filters.

The pool pump lid s o ring will wear out over time and lose its airtight seal allowing air to enter the pool pump from the top.